DIGITAL STIR CONTROLLER (24V)

The Lab Society Digital Stirring Controller lets you connect (and control) the magnetic stirrer motor mounted on the bottom of our heating mantles.

This allows you to have direct control over the RPM of the magnetic stir bar inside the boiling flask.

Features:

• Analog control knob
• Digital RPM readout
• Regulates the speed of magnetic stir bars
• Helps you control vapor pressure
• 24 Vdc input. Level 4, UL/CSA power supply.
• Power supply approvals: UL/CUL/TUV/CB/CE/FCC/EN/EAC/CCC
• For use with custom 24 Vdc stir motor on Lab Society heating mantles
• Backed by Lab Society’s warranty
• Made in the USA

The front of the unit has an on/off switch and an analog knob with a range of 0-100% as well as a digital display which shows the RPM of the magnet inside the heating mantle.

The magnetic stir bar is spun via this integrated controller, allowing you to regulate the input voltage of the resistive devices it is connected to through adjustments to the knob.

The magnetic stir bar will be operational after the correct connections are achieved.

This means that you are able to set the unit to the desired speed, being careful to ensure that the magnet does not start to spin out of control.

We wanted to make sure that you could fine-tune this system to achieve exactly the right setting for your needs in any given situation.

Control your vapor pressure.

The adjustability of the spinning mechanism of this analog stirring controller allows you to have greater control over your vapor pressure, which proves to be very useful in real-world laboratory situations.

The Lab Society custom digital stir controller lets you slow down the stir bar and reduce the overall vapor pressure in the system as you see fit.

Made in the USA.

Made right here in the USA, these units operate at 120 Volts.